Nokia 105 Rm 908 Usb Pinout [WORKING]

| USB-A Pin | Micro-USB Pin | Wire color (typical) | |-----------|---------------|----------------------| | VBUS (+5V) | Pin 1 (VBUS) | Red | | GND | Pin 5 (GND) | Black or bare | | No wire | Pin 2 (D-) | Leave unconnected | | No wire | Pin 3 (D+) | Leave unconnected | | GND (shorted) | Pin 4 (ID) | Connect to GND inside the micro-USB plug. | Solder a jumper wire from Pin 4 (ID) to Pin 5 (GND) inside the micro-USB connector housing. This pulls ID low, signaling the phone to accept charging. Without this connection, the Nokia 105 RM-908 will not charge from many power sources. B. Factory Flash / Data Cable Wiring To enter flashing mode (using Nokia’s proprietary tools like Phoenix Service Software or ATF Box), both D- and D+ need specific connections, usually via a USB-to-serial converter or a "USB to UART" adapter.

| Phone test point | USB-TTL Adapter | |-----------------|-----------------| | TP-51 (RX) | TX (3.3V) | | TP-52 (TX) | RX (3.3V) | | GND (any ground) | GND | Nokia 105 Rm 908 Usb Pinout

Power the phone from its own battery. Use a terminal program (115200 baud, 8N1). At power-on, you’ll see diagnostic output. Using proprietary AT commands, you can dump phonebook via AT+CPBR=? . Q: Can I charge my Nokia 105 RM-908 with any micro-USB cable? A: No. Most modern cables leave pin 4 floating. You need a cable with pin 4 tied to ground, or use the original Nokia charger (which internally shorts ID to GND). Q: Why does my PC recognize a “Nokia USB Device” sometimes? A: If you short D+ and D- together or apply 5V to them, the phone can enter “test mode” – but no user data is accessible. It’s a diagnostic state only. Q: Is the pinout the same for Nokia 105 DS (RM-908 dual-SIM)? A: Yes, identical. The dual-SIM variant uses the same PCB layout and USB pinout. Q: I soldered a new port, still no charge. What next? A: Check the 10kΩ resistor between pin 4 (ID) and ground. It may be damaged. Also verify the charging IC (usually a small 6-pin IC near the USB port) is getting VBUS. 9. Conclusion The Nokia 105 RM-908 USB pinout is simple but non-standard. Its reliance on pin 4 (ID) for charging detection and the absence of functional data lines on D+/D- make it unique among micro-USB devices. By understanding that pin 4 must be grounded, and that pins 2/3 are only for factory flashing, you can repair, modify, and even recover data from this rugged feature phone. | USB-A Pin | Micro-USB Pin | Wire